How do you remove plastic shutter anchors?

It’s simple to remove and replace them using ordinary tools. Place a chisel, bevel side up, on the face of the shutter, with the tip of the chisel below the rounded face or button of the pin. Tap the chisel with a hammer to cut the end off the pin off flush. Pull the shutter off the side of the house. Click to see full answer. Besides, how do you remove plastic shutter screws? Plastic shutter screws are called shutter locks. Put on work gloves and place a ladder next to the window so you can reach the house shutter. Insert a hacksaw blade into the space between the back of the shutter and the wall of the building. Slide the hacksaw blade downward until it stops on one of the plastic nails. Subsequently, question is, how do you reattach a shutter to vinyl siding? How to Reattach Vinyl Shutters Clean and repair the shutter. If the shutter was blown off the house due to bad whether, inspect it thoroughly before reattaching it next to the window. Inspect the holes in the house that you will screw the shutter into. Locate someone to assist in holding the shutter in place during reattachment. Furthermore, how do I remove the shutter anchor? The only way to remove broken shutters with this type of fastener is to cut off the fastener. Pull the shutter away from the siding just enough to allow you to slide a small chisel into the opening. Move to the next fastener on the shutter, and continue to cut off the remaining fasteners for that shutter. How do you remove shutter fasteners from Brick? 2 Answers Find a long metal screw, and pick a drill bit appropriate for pre-drilling that screw. Drill into the remaining shank of the Shutter-lok, all the way to its end. Screw the long metal screw into the Shutter-lok. Pull the metal screw out. (Ease it out, rocking and twisting if it resists.)

ncG1vNJzZmivp6x7pLHLnpmroaSesrSu1LOxZ5ufonuotI6hprBllKR6urvUZqmepZ%2Brsm68y5qqraGTYsCpwdOtnKtlkaOwqbvRrGY%3D